Vivotek VIVOTEK IP Camera IP8332, Bullet Network Camera with 1 Megapixel, IR-LED and H.264 compression for O Spécifications Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 148
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
VIVOTEK
User's Manual - 7
Installation
Hardware Installation
1. Loose the waterproof connector, then remove the rubber.
2. Loose the back cover.
3� Tear down the aluminum foil vacuum bag and take out the silica gel� Attach the supplied silica
gel to the inner side of the Network Camera� (Please replace the silica gel with a new one if
you open the back cover after installation�)
4� Make sure all cable lines are securely connected�
5� Tighten the back cover, rubber and waterproof connector
6� Secure the Network Camera to the wall/ceiling by the supplied camera stand�
Note
If you want to use your own cable lines, please loose two supplied screws and take out the
power board� Then be careful to make connections as the illustration shown below
1
2
3
Silica gel
6
5
Ceiling Mount
Wall Mount
Power Cord
Terminal Block (from left to right)
1: AC24V (red)
2: AC24V (red)
3: DI (white)
4: GND (black)
Ethernet Cable
Screws
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 147 148

Commentaires sur ces manuels

Pas de commentaire