Vivotek IP3111/IP3121 Manuel d'utilisateur télécharger pdf (Page 16)

www.vivotek.com

T: 886-2-22404099

F: 886-2-22404097

Software configuration

Easy way with installer program

In order to configure NetworKams remotely, administrators should keep the serial numbers of the new

NetworKams for identification and initial passwords. After successfully mounting NetworKams in the

proper position, run the Installer program on the appropriate PC to locate the newly installed

NetworKams. NetworKams also support manual setup procedures to non-Windows based environments.

The manual procedure is described next.

After the POST is done, NetworKam will try to configure itself by detecting the network environment. If

there is DHCP service over the network, the Installer program will catch the given information and

display the serial number and given IP address for each NetworKam as following figure. If no DHCP

service is available, a previous IP address will be displayed instead. In that case, it may be 0.0.0.0 for a

brand new unit. When multiple units are mounted, there may be several entries shown in the window.

Administrators may click on each entry with "Assigned" field labeled "No" to install sequentially.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 89 90

Pas de commentaire

Vivotek IP3111/IP3121 Manuel d'utilisateur Page 16