Vivotek SD8362E Guide d'installation télécharger pdf (Page 5)

EN-4

Hardware Installation

Mounting the Network Camera

1. Attach the alignment sticker to the wall.

2. Drill four pilot holes into the wall.

3. Attach the black cover to the Network Camera using the supplied four black

screws.

4. Stick the supplied two pieces of moisture absorber symmetrically to the inner

side of the dome cover. Then place the metal ring into the dome cover to x the

moisture absorber.

5. Fix the dome cover to the Network Camera and secure it by rotating it clockwise.

6. Loosen the three screws on the front opening of the wall mount bracket.

7. Place the O-ring on the front opening of the wall mount bracket.

8. Feed the cables through the front opening of the wall mount bracket and pull them

from wall outlet.

9. Attach the Network Camera to the wall mount bracket by tightening the three

screws on the front opening of the wall mount bracket.

10. Fasten the wall mount bracket to the wall.

Silica gel

1 2 3 4 5 6 7 8 9

Pas de commentaire

Vivotek SD8362E Guide d'installation Page 5