Vivotek FE8181 Guide d'installation télécharger pdf (Page 9)

EN - 8

Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch.

When using a non-PoE switch

Power over Ethernet (PoE)

The Network Camera is PoE-compliant, allowing transmission of power and data via a single Ether-

net cable. Follow the below illustration to connect the Network Camera to a PoE-enabled switch via

Ethernet cable.

When using a PoE-enabled switch

POW

ION

RECEIVE

PARTITIO

PoE Switch (802.3at)

PoE 802.3at Power

Injector (optional)

Non-PoE Switch

NOTE:

1. This equipment is only to be connected to PoE networks without routing to outside plants.

2. For PoE input, use only UL listed I.T.E. with PoE output.

IMPORTANT:

When IR lights are on in the night, the total power consumption is 23W. A 802.3at PoE PSE, e.g., PoE

switch, is required.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Vivotek FE8181 Guide d'installation Page 9