Vivotek CC8130 Guide d'installation télécharger pdf (Page 5)

EN - 4

Mounting the Network Camera - Wall Mount

1. You can install the camera to a vertical surface by driving screws through the holes shown below.

2. You may also install the bracket to a 4” x 2” utility box (as outlet or switch socket).

3. Another option is using the 15° tilt bracket so that the camera can be installed to an over-looking

position. Attach the bracket to a utility box, and then secure the mount bracket. You can route the

cable through the hole in the middle.

2 3

4. Attach a rubber seal pad to the bottom of the mount bracket.

5. Install the camera. Make sure the RJ-45 connector is properly connected.

15° tilt bracket

1 2 3 4 5 6 7 8

Pas de commentaire

Vivotek CC8130 Guide d'installation Page 5