Vivotek IP8330 Guide d'installation télécharger pdf (Page 5)

EN-4

Hardware Installation

1. Loose the waterproof connector, then remove the rubber.

2. Loose the back cover.

3. Tear down the aluminum foil vacuum bag and take out the silica gel. Attach the

supplied silica gel to the inner side of the Network Camera. (Please replace the silica

gel with a new one if you open the back cover after installation.)

4. Make sure all cable lines are securely connected.

5. Tighten the back cover, rubber and waterproof connector.

6. Secure the Network Camera to the wall/ceiling by the supplied camera stand.

Silica gel

Ceiling Mount

Wall Mount

Note

If you want to use your own cable lines, please loose two supplied screws and take out

the power board. Then be careful to make connections as the illustration shown below.

Power Cord

Terminal Block (from left to right)

1: AC24V (red)

2: AC24V (red)

3: DI (white)

4: GND (black)

Ethernet Cable

Screws

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Vivotek IP8330 Guide d'installation Page 5