Vivotek IP8131W Manuel d'utilisateur télécharger pdf (Page 19)

VIVOTEK

User's Manual - 19

WPS

1� Make sure your AP (Access Point) and Operating System support WPS (Wi-Fi Protected

Setup) functions� WPS enables easy setup with compatible APs�

2. Disconnect your LAN cable, and connect the power cord.

3� Wait for 1 minute for the camera to boot up� Press the WPS button for 1 second� The

front panel LED should blink blue�

4� Press and hold down the WPS button on your AP (some router/AP

will have a virtual button on their management software instead)�

Refer to your AP's documentation for details using its WPS

functions�

When WPS conguration is done, wireless connectivity will be established and the

security encryption, such as WEP or WPA-PSK, will be synchronized with the AP.

Use the IW2 utility to nd the camera. As for IP setting, the camera's use of DHCP or

static IP is determined by your conguration on the network camera via the web-based

conguration of rmware. The camera's default is DHCP.

NOTE:

WPS Button

Wireless AP

1� It is strongly recommended to apply WPA2/AES encryption for access security�

2. WPS may not work if your AP is congured with a "hidden" SSID.

3. If no WPS-enabled AP is detected, and if the camera still can not detect an AP after 2

minutes, the wireless setup will be cancelled. If WPS conguration should fail, wireless

conguration will be cleared. You can then re-try the process above or use a wired

connection to establish a web console and manually congure the wireless settings.

4. If a camera is assigned with a xed IP outside the AP's network segment, wireless setup

will fail�

5. A wired connection always has a higher priority, and hence wireless setup will not take

effect when the RJ45 LAN port is connected� If you want to switch from wired connection

to wireless connection, disconnect the Ethernet cable and reboot the camera.

Wireless Connection: Using the WPS Button

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 194 195

Pas de commentaire

Vivotek IP8131W Manuel d'utilisateur Page 19